Got brick when updating firmware.Hi Guys, i need some help. Yesterday I update firmware 5.1.2.0A via recovery method with clear data. The checking firmware and upgrading was fine. but it stuck at flyme logo and keep rebooting until it stuck at meizu logo. So i downloaded test firmware 5.5.12.29A and update via recovery. after finish loading Upgrading. my phone come blank and no sign of flyme logo. i’m try reboot my phone and can’t go to recovery mode. but i can go to flastboot mode when i pressed vol - + power. Any solution for my problem? TQ
| |
|
|
|
|
suggest you go to the After-sale Service Center to deal with this problem,because you can neither go to the fastboot mode nor the recovery mode,It's hard to enter the system normally
| |
|
|
|
|
Note: The author has been banned or deleted.
| |
|
|
|
ultrametric replied at 2016-01-07 02:42 | |
|
|
|
|
With an unlocked bootloader or with a working Flash Tools for this device would be easily repaired, but this is not the case..
| |
|
|
|
|
Edited by mrh4s at 2016-03-15 03:53
MZsimon replied at 2016-01-07 06:20 last week, it was miracle i can boot up the phone into the system. but only last about half an hour. then it restart. come out android upgrading... until it stuck at flyme logo, heat up back cover at area main board and keep restarting until it blank | |
|
|
|
|
unlucky
| |
|
|
|
6